Standard Features

  • Mast: 35 ft. high telescoping mast with 10 ft. maximum layback
  • Capacity: 2,000 lbs. single line, 6,000 lbs. with 3 part line
  • Mainline speed: 150 feet per minute
  • Mainline cable: 3/8" X 150' with open wedge spelter
  • The mainline spool is driven by a heavy duty pinion gear with the pinion shaft direct coupled to the hydraulic motor.  Braking is accomplished with a Hunke automatic fail safe brake.
  • Line Block: Block for reeving a 2 part or 3 part line
  • Hook: 3 ton safety hook
  • PTO for standard transmission with direct mounted pump (PTO is available for an automatic transmission at additional cost)
  • Hydraulic pump: Gear pump
  • Hydraulic bypass valves are incorporated to protect from overloading
  • Rear hydraulic outriggers with holding valves
  • Holding valve on mast cylinders
  • Gray paint


The 4T is designed for fast line speed while maintaining 3 ton capacity.  Fast and easy setup by means of a self supporting mast with two 3 1/2" bore hydraulic cylinders.  A guy cable is not needed in most situations.  Designed to allow for easy access to hard-to-get-to pumps and windmills.  The 4T is designed to mount on 3/4 ton or larger truck.  Weight is approximately 2,200 lbs.

The 4T may be mounted in a 48" x 9' utility body or on a deck.

The open frame design allows for full use of the deck area for cargo and other work tools.

Operating controls are conveniently located at the left rear corner of the rig and are accessible from ground level.

The optional sandline winch has a bare spool lifting capacity of 1,000 lbs. with a line speed of 325 ft. per minute.  It is power-up and power-down and also incorporates a heavy duty clutch for free-fall.  Braking is accomplished with a Hunke automatic fail safe brake.  Spool cable capacity is 1,650 ft of 1/4" cable, 1,050 ft of 5/16" cable or 740 ft of 3/8" cable.